Aj-antunes-co HDH-4 9300130 User Manual download pdf (Page 6)

6

P/N 1010736 Rev. G 05/14

INSTALLATION

Unpacking

1. Remove unit and all packing materi-

als from shipping carton.

2. Open the large box. Remove all

packing materials and protective

coverings from the unit and parts.

NOTE: If any parts are missing or dam-

aged, contact A.J. Antunes & Co.

IMMEDIATELY at 1-800-392-7854

(toll free in the U.S. and Canada)

or at 630-784-1000.

3. Wash all components in soap and

water. Wipe all surfaces of the unit

with a hot damp cloth.

NOTE: Do NOT use a dripping wet cloth.

Wring out before use.

4. Install components in unit.

Equipment Setup

When placing the unit into service, pay at-

tention to the following guidelines.

y Make sure power is oﬀ and the

unit is at room temperature.

y Do NOT block or cover any

openings on the unit.

y Do NOT immerse cord

or plug in water.

y Keep cord away from heated surfaces.

y Do NOT allow cord to hang over

edge of table or counter.

y Place unit on a sturdy, level

table or work surface.

Ensure that the line voltage corresponds to

the stated voltage on the unit speciﬁcation

label.

Ensure the power to the unit is turned oﬀ

before plugging in the power cord.

NOTE: The power cord for Mfg. No.

9300132 is located on the left

side of the unit. See note on page

11.

BASKET

TR AY

BULKHEAD

RACKS

CAUTION

All electrical connections must be in

accordance with local electrical codes

and any other applicable codes.

WARNING

y ELECTRICAL SHOCK HAZARD.

Failure to follow the instruc-

tions in this manual could result

in serious injury or death.

y Electrical ground is re-

quired on this appliance.

y Do NOT modify the power sup-

ply cord plug. If it does not t

the outlet, have a proper outlet

installed by a qualied electrician.

y Do NOT use an exten-

sion cord with this unit.

y The unit should be grounded ac-

cording to local electrical codes to

prevent the possibility of electri-

cal shock. It requires a grounded

receptacle with separate electrical

lines, protected by fuses or circuit

breaker of the proper rating.

y Check with a qualied electrician

if you are unsure if the appli-

ance is properly grounded.

Figure 1. Hot Dog Hutch Components (HDH-3 Shown)

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments